Electronic EGT Controller

$67.81 $62.72

  • Gives a warning light when it starts to work, you can adjust it at any time
  • 16-bit microprocessor controlled and equipped with state-of-the-art digital hardware.
  • Electronic circuit with SMD technology.
  • Installation is done by the retrofit method.
  • The controller uses an industrial microcomputer control system, stable performance, simple operation.
  • Using the K-type thermocouple temperature probe, with easy installation, high temperature, long life, and other advantages.
  • 2-year warrant

Product Description

  • Input voltage: DC 12V
  • Motherboard Power: <3W
  • Temperature Controller Board Temperature range: -30 ~ 999℃
  • Measuring input: K-type thermocouple
  • Temperature measurement accuracy: ± 1 ℃
  • Analog output: 0-5V (For ECU’s, data loggers and etc.)
  • Output Type: one relay output
  • Display window: 38 * 20mm
  • Size: 79 * 51 * 27mm

Download EGT Controller Pdf

6 in stock (can be backordered)

Description
Reviews (0)

Included:

  • EGT K TYPE Thermocouple Amplifier Controller & Gauge & Analog Output
  • Optional EGT Sensor/ K Thermocouple Probe
  • 1 meter/3.3 ft cable
  • Instruction Manuel

Settings:
Power emperor window shows the current real-time temperature
Ent: Enter, according to a determined set value, press switch can be realized.
SET: Setting key, press once to enter the main menu (F1-F5)
“+” Plus key: increase the value display panel
“-” Minus key: decrease the value of the panel display

Internal Setting Description:
Press the SET panel display F1-F5, can be set for each parameter by key operation
F1: Set the desired temperature
F2: Setting the operating mode H = Heating, C = [refrigeration] This step is very important.
F3: Hysteresis setting, which is the number of degrees down to work again.
F4: Temperature correction, real-time display value = value + correction
F5: High-temperature alarm, reaches this temperature the thermostat will prompt alarm

Instructions
Set the target temperature value F1 (stop temperature)
Setting the F2 pattern, H is heating, C is Cooling
Setting back the difference, (the number of stop-start to fall again)

Display:
LLL / HHH: Sensor fault or sensor not connected
Mode / Cooling: lights shows that the current mode is a cooling mode
Mode/heating: Lit describes the current mode is a heating mode
Start: Lit explained that it had started the output relay is closed

Note: Relay output interface is a switch when it working, these two ports are connected. If not work, these two ports are not connected.

Reviews

There are no reviews yet.

Be the first to review “Electronic EGT Controller”

Your email address will not be published. Required fields are marked *